Amirkabir University of Technology Amirkabir Journal of Civil Engineering 2588-297X 53 10 2021 12 22 Experimental investigation and statistical analysis on structural design and impact strengths of fiber geopolymer mortar Experimental investigation and statistical analysis on structural design and impact strengths of fiber geopolymer mortar 4305 4324 4031 10.22060/ceej.2020.18317.6831 FA Mohammad Hossein Dalvand Faculty of Civil Engineering, Semnan University, Semnan, Iran 0000-0001-9459-4847 Mohammad Kazem Sharbatdar Semnan University 0000-0001-6106-1235 Ahmad Dalvand Lorestan University Journal Article 2020 04 24 Due to the high consumption of mortar and concrete, especially in structures and the increasing demand for cement production, considering the environmental degradation effects of this substance, it seems necessary. One of the solutions is to produce environmentally friendly materials and reduce the damaging effects of Portland cement production, Such as slag geopolymer mortar and concrete. The purpose of this paper is to experimentally investigate the statistical approach of the mechanical and resistive properties of cement mortar and geopolymer fibers mortar. Four mix designs, including three geopolymer mix designs with 0, 0.5, and 1% steel micro-fibers and a conventional mortar mix design, were considered. A total of 320 specimens were made, each consisting of 20 cubic specimens, 20 cylindrical specimens, 20 small beam specimens, and 20 small disc specimens. The results indicated that by increasing the percentage of steel microfibers up to 1% in geopolymer samples, the compressive strength, tensile strength and modulus of rupture increased by 6.39, 60.86, and 63.40%, respectively. The number of destruction resistance blows was also about 25 times higher. In all compressive, tensile, flexural, and impact strengths tests, the non-fiber geopolymer specimens had better behavior than conventional cement mortar specimens. In all geopolymer specimens with increasing fiber percentage, standard deviation and coefficient of variation increased as a result of data dispersion. Due to the high consumption of mortar and concrete, especially in structures and the increasing demand for cement production, considering the environmental degradation effects of this substance, it seems necessary. One of the solutions is to produce environmentally friendly materials and reduce the damaging effects of Portland cement production, Such as slag geopolymer mortar and concrete. The purpose of this paper is to experimentally investigate the statistical approach of the mechanical and resistive properties of cement mortar and geopolymer fibers mortar. Four mix designs, including three geopolymer mix designs with 0, 0.5, and 1% steel micro-fibers and a conventional mortar mix design, were considered. A total of 320 specimens were made, each consisting of 20 cubic specimens, 20 cylindrical specimens, 20 small beam specimens, and 20 small disc specimens. The results indicated that by increasing the percentage of steel microfibers up to 1% in geopolymer samples, the compressive strength, tensile strength and modulus of rupture increased by 6.39, 60.86, and 63.40%, respectively. The number of destruction resistance blows was also about 25 times higher. In all compressive, tensile, flexural, and impact strengths tests, the non-fiber geopolymer specimens had better behavior than conventional cement mortar specimens. In all geopolymer specimens with increasing fiber percentage, standard deviation and coefficient of variation increased as a result of data dispersion. https://ceej.aut.ac.ir/article_4031_3be0214185d6177a9aa6adea5a720b09.pdf